Â鶹ÊÓƵ

Causes of bucket failure and repair methods

Causes of bucket failure and repair methods

Source: Hamac Machinery
Reasons for bucket failure:

1.The right PPC valve stick oil path is blocked.

2. The spool of the bucket control valve is worn.

3. The bucket compensation valve is damaged.

4. The spool of the suction valve of the Carter excavator bucket is stuck or the spool is worn, or the seal of the suction valve of the bucket is damaged.

5.The backup valve of the LS shuttle valve fails.

6.The oil passage of the bucket is blocked and the oil supply is not smooth.

Repair method of failure:

1.The bucket control lever is in the middle position, the PPC output pressure is 0; the bucket is digging or unloading, the PPC output pressure is 2.9mpa.

2. Check that the spool in the control valve of the excavator bucket is not worn, the spool of the suction valve of the bucket is not stuck, and the seal is not damaged.

3.Check that the LS shuttle valve of the backup valve control valve is working normally.

4. Turn off the excavator engine, and operate the excavating action of the bucket when the engine is at a high idle speed. The measured oil leakage of the bucket excavation overflow cylinder is 15cc/min, and the specified 20cc/min is low. The troubleshooting method: clean up Unblock the oil path of the excavator bucket

There is no lowest price, only lower price. You get what you pay for. We hope you are looking for the perfect working performance of the equipment, not the low-priced inferior goods. Â鶹ÊÓƵ only provide our clients with high quality machines. Wish a cooperation with you in the future.

Products

Â鶹ÊÓƵ High Quality and full range of equipments High Quality and full range of equipments

Global case

Â鶹ÊÓƵ Free budget analysis, program planning Free budget analysis, program planning

Solution

Â鶹ÊÓƵ Service that exceeds expectations Service that exceeds expectations